Wavlink AC1200 setup
Education

Manual Setup Steps Of The Wavlink Extender

The manual Wavlink AC1200 setup is totally a by-hand setup. You have to connect the wires yourself. When connecting your router, be sure to follow these requirements: Make sure your existing router is connected to your Extender first. Then, connect a computer to a router network. The next step is to configure the router so that you can access the Internet. Use these steps to connect the wireless router: You should start by connecting all the devices such as the wireless router and modem to your computer. Then, just power off the computer. Once you have turned off the device, unplug the wire. Connects the extender to the computer by detecting the ethernet wire. Now, disconnect the computer from the end. Connect the ethernet wire to the internet port of the wireless router. Finally, take off the blue wire that comes along with the router, then again connect it to the LAN port. Make sure to use the ethernet port of the computer. Note: To this exact point your process if gone well then your network cables have formed a good connection, and you are all set to use the networks. For more queries contact us through wifi.wavlink.com.